Keep your fleet flight-ready
Every UAV we assemble in Ecuador is backed by a certified workshop and technicians trained by the manufacturer. We service airframes, propulsion, avionics, payloads and ground stations, so your aircraft returns to the field calibrated, tested and documented, without shipping it overseas.
Preventive maintenance
Inspections by flight hours or calendar interval, before a fault grounds the aircraft.
- Structural and airframe inspection
- Motor, ESC and propeller check
- Battery health and cycle report
- IMU, compass and RTK calibration
- Firmware and parameter review
Corrective repair
Diagnosis and component-level repair after an incident, hard landing or in-flight failure.
- Flight log and telemetry analysis
- Fuselage and arm replacement
- Gimbal and camera bench repair
- Wiring, connector and power bus work
- Post-repair test flight
Overhaul and upgrades
Extend the service life of an existing platform or adapt it to a new mission profile.
- Full teardown and rebuild
- New payload integration
- Datalink and antenna upgrade
- Ground station modernization
- Spare parts from local stock
How a service order works
Six stages, from the moment the aircraft reaches our workshop until it flies again.
-
Intake
We register the aircraft, its serial numbers and accumulated flight hours.
-
Diagnosis
Bench testing and flight log analysis to isolate the root cause, not the symptom.
-
Quotation
You receive an itemized report with parts, labour and turnaround time before we start.
-
Repair
Component-level work with original spares held in our Ecuador warehouse.
-
Test flight
Calibration, hover check and a full mission profile flown by our pilots.
-
Delivery
The aircraft ships back with a signed service record for your maintenance file.
What we service
Multi-rotor, fixed-wing and VTOL platforms, plus the equipment that flies with them.
Airframe and propulsion
- Carbon fibre structure repair
- Brushless motors and ESCs
- Landing gear and folding arms
- Parachute recovery systems
Avionics and control
- Flight controllers and GNSS/RTK
- Radio links and telemetry
- Antennas and signal tuning
- Firmware and failsafe setup
Payloads and energy
- Gimbal cameras and thermal sensors
- Payload drop systems
- Smart battery diagnostics
- Chargers and ground stations